Stainless steel, 3/8–16 x 1.5 inch long cup-end set screws. These longer studs are recommended for those using Zu Rubber Footers as they increase your speaker hight and lean-back angle potential.
Sold in sets of four (4x). If you need enough for a pair of loudspeakers (1x left, 1x right) order two sets.
Locking the stud to the rubber footer requires the use of the original jam nut (9/16” wrench size) and use of a 3/16” hex key.
Link for the stainless 3/8–16 jam nuts if needed.
These measure a half inch [13mm] longer than the original equipment, pre-installed footers that many Zu Audio speakers come with. They are intended to be used with Zu Rubber Footers. The longer stud allows increased thread travel for more lean-back angle or hight adjustment.
Stainless steel, 3/8–16 x 1.5 inch long cup-end set screws. These longer studs are recommended for those using Zu Rubber Footers as they increase your speaker hight and lean-back angle potential.
Sold in sets of four (4x). If you need enough for a pair of loudspeakers (1x left, 1x right) order two sets.
Locking the stud to the rubber footer requires the use of the original jam nut (9/16” wrench size) and use of a 3/16” hex key.
Link for the stainless 3/8–16 jam nuts if needed.
These measure a half inch [13mm] longer than the original equipment, pre-installed footers that many Zu Audio speakers come with. They are intended to be used with Zu Rubber Footers. The longer stud allows increased thread travel for more lean-back angle or hight adjustment.
