[Add] Rubber Footers - 4 Pack

[Add] Rubber Footers - 4 Pack


Out of stock. Orders for the rubber footers placed today will ship USPS November 1.

Protect your floor and improve your sound. Order two packs, one set of four for the left speaker, another set for the right. These new rubber footers spin right on to the pre installed stainless ball-end studs.

Add to Cart

Simple to install, these rubber feet have a threaded insert that fits the original ball-end screws that are pre-installed on your Omen speakers. Simply remove the nut from the ball-end screws, located on the bottom of the speaker, then adjust the screw so there is about a 1/2” [12mm] visible. Now spin the rubber foot onto the screw by hand, snug is tight enough. The only tool you need is a wrench to loosen the 9/16” [14mm] ball-end screw nut.

  • Protect your wood or tile floor without having to slide coins or glides under the original equipment ball-end footers.

  • These specifically engineered rubber-type footers will significantly reduce the transmission of vibration between the loudspeaker and the floor. In most cases this reduces noise and improves resolution.

  • Where spike poke through the carpet and couple the mass of the speaker and the floor, these footers decouple. Decoupling lowers the loudspeaker’s fundamental resonance significantly.

  • Your neighbors will also be less annoyed as these feet will significantly reduce the number of calls you get from those living under you.

  • When installed, the gap-hight (the space between bottom of speaker and floor) is no longer altered by adjusting the footer, instead use magazines (Rolling Stone fits perfect) or the like between floor and loudspeaker bottom to create the desired gap. [Details on gap here]

  • Made in Ohio for Zu by Tech Products.

  • Thread size is 3/8-16


Dims are in inches.