Wasatch Speaker Cable #15

Wasatch Speaker Cable #15

from 39.00

Very limited quantity, when gone they're gone for good. This cable is excellent for bookshelf and systems using 200W per channel amplifiers and under. It is thin and very easy to work with, even if your receiver and speakers have spring-type connectors.

New old stock cable—forgotten inventory from two decades past. Designed for Wasatch by Sean Casey (a minor shareholder at the time) in 1999 and made to spec by Genesis Wire & Cable in Ogden, Utah.

Audio performance and noise rejection are similar the Wasatch Cable LC-601 and to our Mission LC but with less conducting area. This cable is all about easy of use, small size, and huge bang for your buck.

Price is for a matched pair, one left, one right cable, prepped and stripped with bare wire ends. For modest surcharge you can have us install your choice of quality ITT banana plugs or our pure copper spades.

This is a great sounding cable, with excellent resolution without being treble-forward or too rich.

  • Cable is made up of 4x #18 wires in quadrupole.
  • #15 positive (+), #15 negative (–).
  • 0.025 ohm resistance, 0.05 ohms Rs loop / 8' [2.5m].
  • 3nF parallel capacitance 8' [2.5m].
  • 5µH series inductance, 3.6µH Ls loop / 8' [2.5m].
  • 50 volt test.
  • Low characteristic impedance.
  • RF noise immunity is about 20dB better than twister pair.
  • Conductor is oxygen-free copper.
  • Polyethylene conductor insulation material.
  • Very skinny design for low visual impact.
  • 100% made in Ogden, Utah, USA.

Despite being a closeout, these are complete with our 60-day 100% money-back guarantee and we'll pay return shipping.

Ships free via USPS First Class.

Price is for a matched pair (one left, one right).

Length:
Termination:
Quantity:
Add To Cart

Directionality

Wasatch Cable Works LC-601 is not a permanently directional cable; it can be used in either direction. However, we recommend you connect it so that the writing on the cable reads from the amplifier to the loudspeaker. Connecting it like this ensures matching channel fidelity, equal L/R burn-in results, and allows the user to easily identify direction after cable or gear swapping or cleaning.

Burn-in

Wasatch Cable Works LC-601 was designed to sound good right out of the box. However after about 200 hours of play thy will sound better. We do not recommend any burn-in devices or special recordings—just the music you enjoy, preferably upbeat full spectrum recordings: rock, roots, full orchestra, big band.... For the possible how and whys about burn-in please see our Answers section.

Maintenance

No maintenance is required for the cable or the connectors save for the annual bare copper or copper spade cleaning. If your connector or bare wire contacts are nice and bright, don’t worry about it. However, anytime you are making an electrical connection make it a habit to inspect the contacts and clean them if they are tarnished or dirty.